Module is a bass preamp pedal based on our Terra Nova amplifiers. It features the semi-parametric EQ section, as well as the Enhance EQ sweep, Bass Boost and switchable compressor. Module also includes three foot-switches to toggle the Mute, Enhance & Effects Loop easily whilst playing.
Use the Module to take your sound to the front of house, recording desk or your existing power amp, or use the headphone output and 3.5mm line in connectivity to rehearse without disturbing the neighbours. Module is the perfect travel companion.
|Power Supply:||15-18V DC power supply (included)|
|Dimensions:||H: 7 cm
W: 26 cm
D: 16 cm
Plug your active or high output bass in here.
Plug your passive or low output bass here.
Press this switch to mute and un-mute the amplifier. When the amplifier is muted the light will illuminate.
Use this switch to turn the built in compressor circuit off and on. This LED will illuminate when the compressor feature is switched on.
Adjust the low frequencies of the amplifier using this
Change the amount of frequency adjustment by the low mid freq sweep using this dial.
Adjust the frequency affected by the upper mid freq sweep using this control.
Controls the overall volume of your amplifier.
Adjust the frequency affected by the Low
Mid control from 30 Hz up to 300 Hz using this control.
Adjust the frequency affected by the Hi Mid control from 200 Hz up to 2000 Hz using this control.
Adjust the highest frequencies on the amplifier using this
Illuminates when unit is switched on.
Use this control to adjust the amount of signal sent into
the preamp stage. Use in conjunction with the Input Gain clip light to avoid clipping the input stage of the amplifier.
This EQ sweep allows quick and effective adjustment of your EQ with a single dial. For best results use the Enhance control with all other EQ settings at 12 O’clock before detailing your tone.
Use this switch to turn on the Bass boost feature on the amplifier. When engaged the Bass control will provide more pronounced Bass adjustment.
Use this switch to toggle the Mute setting. This LED will illuminate when the pedal is muted.
Use this switch to turn the Enhance feature off and on. This LED will illuminate when the Enhance feature is switched on.
Use this switch to either include or bypass the Effects Loop. This LED will illuminate when the effects loop is active.
Plug your supplied power cord into your Eden amplifier using this mains inlet socket.
Choose the polarity to suit your power supply.
Send your signal to a power amp or mixing desk using a 1/4” Jack cable.
Connect an external device, such as an MP3 player, here using a 3.5mm jack cable.
Connect your headphones here using standard 3.5mm headphone cable.
Connect your foot controller here.
Take your signal to/from your external effect loop or outboard equipment here.
Choose to take the DI signal from either before or after the preamp shaping circuit inside the amplifier.
Connect to either a mixing desk, front of house system or recording device using a standard XLR cable.
Lift ground from your signal (when required) using this switch.
DI Pad: Pad the signal (reduce the output level) between line level and mic level using this switch.
Take your tuner signal out from this socket.
Back to top